Septic inspections best provider in Sonora

Septic systems high quality services in Valley Springs, CA? Never drain your pool or hot tub water into your septic tank system. Chlorine from your pool or hot tub can break down the important solid-busting bacteria in your system, just like household chemicals can. Additionally, adding a large influx of water into your septic tank can cause your drain field to flood. Perform an inspection of your septic tank on a regular basis. The frequency of a septic tank inspection depends on the manufacturer – it can range from three months to three years. Some septic tanks can be inspected by the consumer while others need to be inspected by a technician. In any case, be sure to have your septic tank system evaluated on a frequent basis to catch any minor repairs before they become costly ones.

Septic cleaning products are available to break up blockages in the pipes. Tree roots are a common blockage in older septic systems. Root killers, available at local hardware stores, can be used routinely to help prevent their spread. A pump tank is controlled by either control floats or timer controls. It also requires electricity to operate so limit water use if there is a power outage. If the capacity in the tank is too high or too low or a malfunction occurs, most systems are equipped with a red alert alarm (located on the top of the control panel) to warn the homeowner. Limit water use through a couple of pump cycles (10-15 hours) to see if the alarm goes out on its own. If the red light goes out, the system is working properly. If not, continue to limit water use and consult a professional septic service provider for advice.

When it rains and the ground gets saturated, ground water can enter the system. This can cause leach field saturation as additional water is introduced to the tank through I&I which can be more than your leach field can absorb. You will see water ponding over your leach field or running above the ground. On dosing systems, the computer can sound audible alarms. I&I also lets red worms make it through into your system filter pod (if you have this type of system). The worm’s waste, called “castings” clog the filters causing ponding and ruins the pretreatment your system was designed for. Read more information at look here.

To keep your septic tank and drain field in working order, having the tank pumped on a regular basis is essential. How often you will need to have your system pumped depends on the size of your household, total wastewater generated, the number of solids, and the size of your tank. The official EPA recommendation is that you have the system pumped every 3-5 years, but it’s a good idea to have it inspected and serviced more often than that. In addition to regular tank pumping, the most important thing you can do for your septic system is to be careful about what goes into it.

Slower percolation rates due to poorly draining soil with clay, bedrock, high ground water, proximity to a creek, or other complications require larger leach fields. There are two methods of calculating the minimum absorption area for a leach field. Traditionally, you dig an eight foot deep test inspection hole in the area of the intended leach field to allow building inspector, or your local engineer, to physically examine the soil and determine its Long Term Acceptance Rate. Or you can have a local soil testing firm perform a percolation test to clock the speed of your soil’s capacity to absorb liquids.

Foothill Sanitary Septic and Foothill Portable Toilets has been serving California in the Calaveras, Tuolomne, Amador, San Joaquin and Stanislaus Counties for many years. With locations in Copperopolis, Valley Springs and Arnold we are equipped to fulfill all of your septic or portable toilet needs in a timely manner to your complete satisfaction. We’re committed to providing you with the highest level of service, so you’ll always choose us for your septic pumping, maintenance and repair needs.

A Dosing System introduces the effluent waste water from the septic tank to the drain field in intermittent intervals (doses) throughout the day. This allows the soil to absorb the “dosed” water in the drain field before more water is introduced. These types of systems are used in soils with poor absorption rates or shallow soils. There are two common types of dosing systems: The Siphon Dose and the Low Pressure Dose. A siphon dose system (not pictured) does not use an electrical discharge pump. It uses a siphon bell ( an inverted bell that is open on the bottom and traps air) that cycles as the water level rises and cause the effluent to dose into the drain field by a siphon action (Click on the link to the left to see how it actually works). A low pressure dosing system uses a pump in a pump chamber (as shown in picture on the left). The pump turns on intermittently through electronic controls and sends the effluent to the drain field in intervals throughout the day. Find more information at here.